Epson AcuLaser C8600 - Setting up Your Printer Using Epsonnet Direct Print; Adding a Printer Located in the same Segment

EpsonNet Direct Print
149
9
9
9
9
9
9
9
9
9
9
9
9
Setting Up Your Printer Using EpsonNet
Direct Print
When setting up a printer to print with LPR, you can add both a
printer located in the same segment and one located beyond a
router.
Note:
❏
Be sure that the computer is connected to the network and TCP/IP
is correctly set.
❏
The valid IP address other than default value “192.168.192.168”
must be set; otherwise the printer does not appear under the
Epson_lpr group icon.
❏
TheEPSONStatusMonitor2utility shipped with the interface card
models C82362
✽
/C82363
✽
/C82364
✽
with software version 1.x
and EPL-N2700/N4000 printers enables EPSON TCP/IP printers.
These EPSON TCP/IP printers can coexist with lpr printers added
by EpsonNet Direct Print.
❏
The job control functions such as Cancel Printing and Purge Print
Jobs are available when you double-click the target printer icon in
the Printers folder. However, if the printer has already started
printing a document, the print job may not be cancelled completely.
Adding a printer located in the same segment
Follow the steps below to add a printer located in the same
segment.
1.
Windows Me:
Double-click the
My Network Places
icon.
Windows 98/95/NT 4.0:
Double-click the
Network
Neighborhood
icon.