40
Installing Components on Your Computer
Macintosh
To print using the AppleTalk protocol and configure the Internal
Print Server with EpsonNet MacAssist, you just need to select
Ethernet in the AppleTalk Control Panel. Then configure the
Internal Print Server with EpsonNet MacAssist. See “About
EpsonNet MacAssist” on page 69.
If you use EpsonNet WebAssist or EpsonNet WebManager, set
an IP address to your Macintosh as described below.
Macintosh (with Open Transport)
Follow the steps below to set or check the IP address.
1. Double-click the TCP/IP Control Panel.
2. Set an IP address, and change other settings if necessary.
Macintosh (without Open Transport)
Follow the steps below to set or check the IP address.
1. Double-click the MacTCP Control Panel, and then check
whether an IP address has been set.
2. If no IP address is set, click the Details button and change the
necessary settings. Then, set an IP address in the MacTCP
dialog box.
To Next Page
Loading...
