136
Settings for NetWare Server
❏ When the Internal Print Server is not correctly set
Since access is made only to the primary server, no dial-up is
generated. However, if the file server/print server of the
remote network is erroneously set as the primary server, an
unnecessary dial-up might be generated. Correct the settings
to avoid this problem.
❏ During normal operation (standby/printing)
Since access is made only to the primary server, no dial-up is
generated.
❏ When the primary server is down during operation
Connection to the primary server is periodically attempted,
but no dial-up is generated. However, if the router is set to
pass SAP packets (Find Nearest Server), an unnecessary
dial-up might be generated. To avoid this, turn off the printer
once, or do not allow the router to pass SAP packets (Find
Nearest Server).
To Next Page
Loading...
