Epson AcuLaser C8600 - Page 240

230
Setting an IP Address for the Printer
6. Press the Up or Down button until
Get IP Address = Auto
appears. Press the Enter button and then the Up or Down
button to change to
Get IP Address = Panel
. Then press the
Enter button. You can use the following methods to get an IP
address.
❏ Choose
Panel
when setting the IP address, subnet mask,
and default gateway using the printer’scontrolpanel.
❏ Choose
Auto
when getting the IP address from a DHCP
server. The IP address is automatically obtained from the
DHCP server whenever the printer is reset or turned on.
❏ Choose
PING
when setting the IP address using the
arp/ping command. The Internal Print Server uses the IP
address set by the arp/ping command. The settings
become available when the printer is reset or turned off
and then back on.
Note:
❏ To use Auto, a DHCP server must be installed and correctly
configured on your computer. See the online help of your
operating system for detailed instructions.
❏ Choose PING only when setting the IP address using the
arp/ping command.
7. Press the Up or Down button until
IP Byte 1*
appears. Press
the Enter button.
8. Press the Up or Down button until the desired value appears.
Then press the Enter button to set the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default
gateway.
9. Turn off your printer and then turn it back on. Be sure to wait
until the initialization is complete.