Epson AcuLaser C8600 - Page 247

Setting an IP Address for the Printer
237
B
B
B
B
B
B
B
B
B
B
B
B
3. The Internal Print Server should now respond to the ping. If
it does not, you may have incorrectly typed the MAC address
or the IP address in the arp -s command. Double-check and
try again. If none of these actions are effective, re-initialize the
Internal Print Server and try again.
4. Print a network status sheet to check whether the new IP
address has been assigned to the Internal Print Server.
Note:
When you set the IP address of the Internal Print Server in this way,
you cannot change the subnet mask or the gateway setting of the
Internal Print Server. You must use EpsonNet WinAssist on
Windows (Me, 98, 95, 2000, or NT), EpsonNet MacAssist in
Macintosh, or EpsonNet WebAssist to change these parameters.