B
Enter Scan mode from the Home menu.
C
Select Document Capture Pro.
D
Press the Select Computer field, and then select the computer to which a job has been registered in Document
Capture Pro.
Note:
If you have set a password in Document Capture Pro from the Network Scan Settings in the software, select a
computer and then enter the password.
E
Select a job.
Note:
❏ When you have registered only one job in advance, go to step 6.
❏ To check the job details, press the job contents field on the screen.
❏ To select another registered job, press the job select field again.
F
Press one of the x buttons.
The scanned image is saved to the destination you specified.
Scanning to a computer (WSD)
Note:
❏ This function is only available for computers running Windows 8, Windows 7, or Vista.
❏ To use this function, you need to setup WSD for your computer in advance. For more information, see the online
Network Guide.
A
Place original.
& “Placing Originals” on page 33
B
Enter Scan mode from the Home menu.
C
Select Computer (WSD).
D
Select a computer.
E
Press one of the x buttons and then start scanning. Your scanned image is saved.
Note:
Depending on the version of the operating system, the scanned image is saved to different destinations. For more
information, see your computer’s documentation.
User’s Guide
Scanning
62
To Next Page
Loading...
Need help?
General
