Epson DS-790WN

Mail Server Setting Items
Items Settings and Explanation
Authentication Method Specify the authentication method for the scanner to access the mail server.
O Authentication is disabled when communicating with a mail
server.
SMTP AUTH Requires that a mail server supports SMTP Authentication.
POP before SMTP Congure the POP3 server when selecting this method.
Authenticated Account If you select SMTP AUTH or POP before SMTP as the Authentication Method, enter the
authenticated account name between 0 and 255 characters in ASCII (0x20-0x7E).
Authenticated Password If you select SMTP AUTH or POP before SMTP as the Authentication Method, enter the
authenticated password between 0 and 20 characters in ASCII (0x20-0x7E).
Sender's Email Address Enter the sender's email address. Enter between 0 and 255 characters in ASCII (0x20-0x7E)
except for : ( ) < > [ ] ; ¥. A period "." cannot be the rst character.
SMTP Server Address Enter between 0 and 255 characters using A-Z a-z 0-9 . - . You can use IPv4 or FQDN format.
SMTP Server Port Number Enter a number between 1 and 65535.
Secure Connection Specify the secure connection method for the email server.
None If you select POP before SMTP in Authentication Method,
the connection method is set to None.
SSL/TLS This is available when Authentication Method is set to O
or SMTP AUTH.
STARTTLS This is available when Authentication Method is set to O
or SMTP AUTH.
Certicate Validation The certicate is validated when this is enabled. We recommend this is set to Enable.
POP3 Server Address If you select POP before SMTP as the Authentication Method, enter the POP3 server
address between 0 and 255 characters using A-Z a-z 0-9 . - . You can use IPv4 or FQDN
format.
POP3 Server Port Number If you select POP before SMTP as the Authentication Method, enter a number between 1
and 65535.
Checking a Mail Server Connection
You can check the connection to the mail server by performing the connection check.
1.
Access Web
Cong
and select the Network tab > Email Server > Connection Test.
2.
Select Start.
e connection test to the mail server is started. Aer the test, the check report is displayed.
Note:
You can also check the connection to the mail server from the control panel. Access as below.
Settings > Network Settings > Advanced > Email Server > Connection Check
Required Settings for Scanning > Conguring a Mail Server > Checking a Mail Server Connection
118