Epson DS-790WN

3.
If the Select Computer screen is displayed, select the computer.
Note:
❏ e scanner’s control panel displays up to 111 computers on which Document Capture Pro is installed.
❏ If Server Mode is set as the operation mode, you do not need to perform this step.
4.
If the Select Job screen is displayed, select the job.
Note:
If you have set only one job, you do not need to select the job. Proceed to the next step.
5.
Conrm the computer and the job you selected.
Note:
Select
to save your settings as a preset.
6.
Tap
x .
Document Capture Pro automatically starts on your computer, and scanning starts.
Related Information
& “Setting a Job” on page 111
& “Creating a Job and Assigning a Job to the Control Panel (Windows)” on page 111
& “Assigning a Job to the Control Panel (Mac OS)” on page 112
Scanning to a Network Folder
You can save the scanned image to a
specied
folder on a network. You can specify the folder by entering a folder
path directly, but it may be easier if you register the folder information in the contacts list rst.
Before scanning, you need to set a network folder or FTP server.
Note:
❏ Make sure the scanner’s Date/Time and Time Dierence settings are correct. Select Settings > Basic Settings > Date/
Time Settings on the control panel.
❏ You can check destination before scanning. Select Settings > Scanner Settings, and then enable the Conrm Recipient.
1.
Place the originals.
2.
Select Network Folder/FTP on the home screen of the scanner’s control panel.
Scanning > Scanning Using the Scanner's Control Panel > Scanning to a Network Folder
72