Epson DS-790WN

Job is not assigned to the scanner's control panel.
Solutions
Check that the job is correctly assigned to the scanner's control panel in Document Capture Pro
(Windows) or Document Capture (Mac OS).
& “Creating a Job and Assigning a Job to the Control Panel (Windows)” on page 111
If you are using any TWAIN-compliant programs, the correct scanner is not selected as the
source setting. (Windows)
Solutions
Make sure that you select the correct scanner from your programs list.
AirPrint is disabled.
Solutions
Enable the AirPrint setting in Web Cong.
Cannot Start Scanning from Smart Device
Make sure the smart device and the scanner are connected correctly.
e cause and solution to the problem dier depending on whether or not they are connected.
Checking the Connection Status (Smart Device)
You can use Epson Smart Panel to check the connection status for the smart device and the scanner.
1.
Start Epson Smart Panel on your smart device.
2.
Check whether or not the scanner name is displayed in Epson Smart Panel.
If the scanner name is displayed, a connection has been successfully established between the smart device and
the scanner.
If a message is displayed saying that the scanner is not selected, a connection has not been established between
the smart device and the scanner. Follow the instructions on the Epson Smart Panel to connect to the scanner.
If you cannot connect to the scanner over a network, check the Related Information.
Related Information
& “Cannot connect to a Network” on page 206
Cannot connect to a Network
e problem could be one of the following issues.
Solving Problems > Problems Starting Scanning > Cannot Start Scanning from Smart Device
206