Note:
❏ When scanning originals with punch holes such as loose leaf paper, load the originals with the holes facing to the side
or facing down. ere must not be any holes within a 30 mm (1.2 inches) strip at the center of the originals.
However, there can be holes within 30 mm (1.2 inches) from the leading edge of the originals. Make sure that the
edges of the punch holes do not have burrs or curls.
❏ When scanning thin paper with crinkles that are causing paper jams or double feeds, you may be able to improve the
situation by enabling Slow. To do this, select Settings > Scanner Settings > Slow on the control panel and set it to
On to slow down the feeding speed.
Long Paper
Specications of Long Paper
e
specication
of long paper you can load into the scanner.
Note:
❏ Long paper means originals with a length of 393.8 mm (15.5 in.) or more.
❏ When scanning long paper, scanning speed is reduced.
Size Thickness Paper Type Loading Capacity
Maximum width: 215.9 mm (8.5 in.)
Maximum length: 6,096.0 mm (240.0
in.)
*
50 to 130 g/m Plain paper
Fine paper
Recycled paper
1 sheet
Specications and Placing of Originals
>
Placing Originals
>
Long Paper
45
To Next Page
Loading...
