Epson DS-790WN

Messages Explanation
Authentication failed.
Check the settings.
This message appears for the following reasons:
❏ User Name and/or Password is incorrect.
❏ If Kerberos Authentication is selected as the Authentication Method, the
time/date may not be congured.
Cannot access the product until
processing is complete.
This message appears when the scanner is busy.
Using Document Capture Pro Server
By using Document Capture Pro Server, you can manage the sorting method, saving format, and forwarding
destination of a scanning result executed from the scanner's control panel. You can call and execute a job
previously registered on the server from the scanner's control panel.
Install it on the server computer.
For more information on Document Capture Pro Server, contact your local Epson oce.
Setting Server Mode
To use Document Capture Pro Server, set up as follows.
1.
Access Web Cong and select the Scan tab > Document Capture Pro.
2.
Select Server Mode for Mode.
3.
Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4.
Click OK.
e
network is re-connected, and then the settings are enabled.
Setting Up AirPrint
Access Web Cong, select the Network tab, then select AirPrint Setup.
Items Explanation
Bonjour Service Name Enter a Bonjour service name, using ASCII text (0x20-0x7E) and up to 41
characters.
Bonjour Location Enter a description of the scanner's location, using Unicode (UTF-8) text and up to
127 bytes.
Required Settings for Scanning > Setting Up AirPrint
145