Direct power on
Turn on the scanner directly when the scanner is connected to the power source, without pressing the
power button.
Scanner Settings
Slow
Slows down the feeding speed whenever scanning. When set to On, the icon changes to .
Enable this in the following situations:
❏ When originals jam frequently
❏ When loading thin originals
❏ When scanning dierent types or sizes of originals at once
❏ If you feel that the scanner is noisy
Double Feed Stop Timing
Set the operation when any double feed is detect.
❏ Immediate: Stops feeding immediately
aer
any double feed is detected.
❏ Aer Eject: Originals detected as double feed are scanned as is, and the subsequent feed of originals
is temporarily stopped.
If the scanned image has no problem, you can resume scanning as is.
DFDS Function
Skips double feed detection once and continues scanning. When set to On, the icon changes to .
Enable this to scan originals that are detected as double feeds, for example plastic cards or envelopes.
Paper Protection
Reduces damage to the originals by stopping scanning immediately when the following status is
detected.
❏ A feeding error for the originals occurs
❏ Originals are fed askew
Select the detection level to enable this feature. See the table below for details on each level.
Level Description
On-Low Lower the sensitivity to detect the skew of the originals.
On-Medium Detect the skew of the stapled originals and the skew that On-Low could not
detect.
On-High Increase the sensitivity to detect the skew of the originals.
Menu Options for Settings
>
Scanner Settings
173