Epson DS-790WN

Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the wireless router. If the following
conditions are met, you can set up by using this method.
❏
e
wireless router is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the wireless router.
Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the wireless
router.
1.
Tap
on the home screen.
2.
Select Router.
3.
Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change to Wi-Fi
connection. or Change Settings to change the settings.
4.
Select Push Button Setup(WPS).
5.
Follow the on-screen instructions.
If you want to check the network connection status for the scanner aer setup is complete, see the related
information link below for details.
Note:
If connection fails, restart the wireless router, move it closer to the scanner, and try again.
Related Information
& “Checking the Network Connection Status” on page 230
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to a wireless router by using a PIN code. You can use this method to set up if an
wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the wireless
router.
1.
Tap
on the home screen.
2.
Select Router.
3.
Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change to Wi-Fi
connection. or Change Settings to change the settings.
4.
Select Others > PIN Code Setup(WPS)
Adding or Replacing the Computer or Devices > Re-setting the Network Connection > Making Wi- …
229