Epson DS-790WN

4.
Adjust the edge guides to
t
the edge of the long paper making sure there are no gaps between the edge of the
paper and the edge guides. Otherwise, the originals may be fed skewed.
Note:
❏ See the following for the maximum lengths depending on the situation.
“Maximum Length for Long Paper” on page 37
❏ You need to specify the paper size in the Epson Scan 2 window.
When you are using Document Capture Pro, you can open the window by pressing the Detailed Settings button on
the Scan Settings screen.
ere are three ways to specify the paper size in the Epson Scan 2 window.
If the paper length is 3,048 mm (120 inches) or less, you can select Auto Detect (Long Paper) to detect the size
automatically.
If the paper length is more than 3,048 mm (120 inches), you need to select Customize and enter the size of the paper.
If the paper length is 5,461 mm (215 inches) or less, you can use Detect paper length instead of entering the paper
height. If the paper is longer than 5,461 mm (215 inches), you need to enter the width and height of the paper.
❏ Support long paper at the input side so that it does not drop out of the ADF, and on the output side so that the
ejected paper does not fall from the output tray.
Specications and Placing of Originals > Placing Originals > Long Paper
48