Click Uninstall and start again if the Uninstall screen is displayed.
Note:
e scanner name you set on the network and model name (EPSON XXXXXX (XX-XXXX)) are displayed on the
network screen. You can check a scanner’s name that was set on the network from the scanner’s control panel.
4.
Click the message displayed on the computer, which says that your device is ready to use.
5.
Check the message on the screen, and then click Close.
6.
Open the Devices and Printers screen.
Click start > Control Panel > Hardware and Sound (or Hardware) > Devices and Printers.
Scanning
>
Scanning Using the Scanner's Control Panel
>
Scanning Using WSD
90
To Next Page
Loading...
