Epson LX-810 User Guide

Choosing a Place for the Printer
Note: If you plan to use a printer stand, follow these guidelines:
Use a stand that supports at least 11.6 kg (25½ lbs), which is
twice the weight of the printer.
Never use a stand that tilts the printer at an angle of more
than 15 degrees from horizontal. If you install a cut-sheet
feeder, keep your printer absolutely level.
If you position the paper supply below the printer stand, make
sure that you allow enough clearance (25 mm or 1 inch) to
keep the paper from catching on the underside of the stand.
Also see that the distance between the stand’s supports is at
least 280 mm (11 inches), to accommodate any paper size you
may use.
Position your printer’s power cord and interface cable so that
they do not interfere with paper feeding. If possible, secure the
cables to the printer stand.
l-4
Setting Up the Printer

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)