Epson LX-810 User Guide

Switching between Continuous and Single Sheets
While using continuous paper, you can easily switch to single-
sheet printing without removing the continuous paper from the
tractor.
Switching to single sheets
1. If the printer is on line, press the ON LINE button to set the
printer off line.
2. Tear off all outgoing sheets of continuous paper.
3. Press the LOAD/EJECT button to feed the continuous paper
backward out of the printer and into the standby position.
l
4.
5.
6.
7.
CAUTION:
l
If you are using narrow paper (less than 152.4 mm or
6 inches wide), you should only press the LOAD/EJECT
button once. Also, do not use this button to eject
labels.
l
Never feed labels backward through the printer.
Labels can easily come off the backing sheet and jam
the printer.
Push the paper-release lever back to the single-sheet position.
Stand the paper guide upright and move the left edge guide so
that it locks in place next to the guide mark.
Adjust the right edge guide to match the width of the paper.
Then, slide the paper down between the edge guides until it
meets resistance.
Press the LOAD/EJECT button to automatically feed the single-
sheet paper to the loading position. Then, press the ON LINE
button to set the printer on line.
2-8
Paper Handling

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)