Epson LX-810 User Guide

Setting the DIP Switches
Table 2 International character set and PC selection
Spain
I
I I
PC 437 OFF
OFF
OFF
DIP switch functions
This section describes the different features you can control with
the printer’s DIP switches.
Character spacing
DIP switch l-l controls the character spacing. If this switch is off,
the printer prints with character spacing of 10 cpi (characters per
inch); if it is on, the printer prints with character spacing of 12 cpi.
This is 10 cpi printing.
ABCDEFGHIJKLabcdefghijkl
This is 12 cpi printing.
ABCDEFGHIJKLabcdefghijkl
Shape of zero
When DIP switch l-2 is on, the printer prints slashed zeros (8);
when off, the printer prints open zeros (0).
Page length
DIP switches l-3 and l-4 control the page length. You can select a
page length of 216 mm (8.5 inches), 279 mm (11 inches), 296 mm
(11.7 inches), or 305 mm (12 inches).
Using the Printer 3-7

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)