Power Supply
This section supplies solutions for possible power supply problems.
Power is not being supplied.
l The POWER tight does not go on.
Check that the power cord is properly plugged into the
electrical outlet.
If the electrical outlet is controlled by an outside switch or
automatic timer, use a different outlet.
Plug another electrical device into the outlet to determine
whether the outlet is operating properly.
l The POWER tight comes on briefly and then goes off. The
tight stays off even when the power is turned on again.
Check that the printer’s voltage rating matches the voltage
of your electrical outlet. If the voltages do not match,
unplug the printer and contact your dealer immediately. Do
not reconnect the power cble to an electrical outlet.
Troubleshooting 6-3
To Next Page
Loading...
