Epson LX-810 User Guide

Using Single Sheets
4. Slide the paper down between the edge guides until it meets
resistance.
5. Press the LOAD/EJECT button once to load the paper.
Note: If the platen turns without loading the paper, remove the
paper and re-insert it more firmly. Then press the LOAD/EJECT
button again.
CAUTION: Never advance the paper using the platen
knob while the minter is turned on.
6. Press the ON LINE button to set the printer on line.
To eject the paper, set the printer off line (by pressing the ON LINE
button) and then press the FORM FEED button.
Printing multiple-page documents
When you print a document of more than one page using single-
sheet paper, you must reload paper at the end of each page. To
reload, first see that the printer is off line. (If the ON LINE light is
on, press the ON LINE button once to take the printer off line.)
Then load a new sheet by following steps 4, 5, and 6 above.
If your software has not been set up properly, the printer may
print too low on the second page of a document or print the last
few lines of one page on the next. If this happens, see Tips for
printing on single sheets at the beginning of this manual for
instructions on how to correct the problem.
Paper Handling 2-3

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)