Epson LX-810 User Guide

Assembling the Printer
After choosing a good place for your printer, the next step is to
install the platen knob.
Installing the platen knob
You use the platen knob to manually feed paper in the printer
when the printer is turned off. You will find the platen knob
packed in an indentation in the white foam packaging material.
1. Insert the knob into the hole on the printer’s side and rotate it
slowly until it slips onto the shaft.
2. Push firmly on the platen knob until it fits against the printer
case.
Setting Up the Printer l-5

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)