Epson LX-810 User Guide

Paper Handling
The following section guides you through problems in handling
single sheets and continuous paper. If you are having problems
using the optional cut-sheet feeder, see the section on options
starting on 6-10.
Single sheets do not feed properly.
l Printing starts too tow on the page, or the bottom part of
one page is printed at the top of the next page.
Be sure to choose the correct printer when you choose a
printer from your application program’s menu. See Chapter
1.
If possible, specify single-sheet paper with your application
software.
Use your application software to reduce or eliminate the top
margin and reduce the page length.
l When you press the LOAD/EJECT button, the platen does not
rotate and paper does not feed.
If the ON LINE light is on, press the ON LINE button once to
set the printer off line.
l When you press the LOAD/EJECT button, the platen rotates
but paper does not feed.
Check that the paper-release lever is pushed back to the
single-sheet position.
6-8
Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)