Epson LX-810 User Guide

Paper Handling
. The paper feed is crooked or the paper jams.
The cut-sheet feeder mode may be turned on. Set DIP
switch 2-2 off.
Make sure the paper size is within the specified range. See
7-3.
l The paper does not fully eject.
See that the page-length setting is correct.
Continuous paper does not feed properly.
l The paper feed is crooked or the paper jams.
See that the paper-release lever is pulled forward to the
continuous-paper position.
Make sure that the paper supply is not obstructed by a
cable or some other object.
Make sure that your paper supply is positioned within 1
meter (3 feet) of the printer.
The position of your paper supply may be preventing it
from feeding straight.
See that the holes on the sides of the paper are aligned
with each other. Also, make sure the sprocket units are
locked and their covers are closed.
Check that the paper-thickness lever is set correctly for the
paper you are using.
Check that the paper size is within the specified range. See
7-3.
Troubleshooting 6-9

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)