Epson LX-810 User Guide

Roll Paper Holder
The optional roll paper holder (#8310) allows you to use your
printer with 8.5-inch roll paper like that used with telex machines.
This provides an inexpensive alternative to continuous paper.
Installing the roll paper holder
1. Turn off the printer and remove the paper guide.
2. Position the roll paper holder beneath the printer as shown
below. Fit the two holes in the base onto the two positioning
pegs on the bottom of the printer.
3. Push the paper-release lever to the single-sheet position.
CAUTION: Only the weight of the printer holds the roll
paper holder in place. The positioning pegs only prevent
the printer, be careful to avoid dropping the roll paper
4-14
Using the Printer Options

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)