Epson LX-810 User Guide

Choosing a Place for the Printer
When selecting a place to set up your printer, be sure to keep the
following in mind:
l Place the printer on a flat, stable surface.
Place the printer close enough to the computer for the printer
cable to reach.
l Leave adequate room around the printer to allow for easy
operation and maintenance.
CAUTION: Avoid locations that are subject to direct
sunlight, excessive heat, moisture, or dust.
Use a grounded outlet; do not use an adapter plug.
Avoid electrical outlets controlled by wall switches or
automatic timers. Accidental interruption of power can wipe
out information in the memory of your computer or your
printer.
Avoid outlets on the same circuit with large motors or other
appliances that might cause fluctuations in line voltage.
Keep the entire computer system away from potential sources
of electromagnetic interference such as loudspeakers or the base
units of cordless telephones.
Setting Up the Printer 1-3

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)