Printing
l Regular gaps occur in the printout.
One-inch skip-over-perforation may be set. Set DIP switch
2-3 off.
Your line-per-page setting in your software may be
incorrect.
l Skip-over-perforation is set, but the perforation does not fall
in the center of the skip.
Adjust the loading position. See the section on DIP
switches in Chapter 3.
Make sure the DIP-switch settings match your required
paper length. See the section on DIP switches in Chapter 3.
If your application program is setting the top and bottom
margins, set DIP switch 2-3 off.
If the printer still does not print correctly, try the self test
described in Chapter 1. If the self test works properly, the printer
is all right, and the problem probably lies in the computer, the
software, or the cable. If the self test does not work, contact your
dealer or a qualified service person.
Troubleshooting 6-7
To Next Page
Loading...
