Epson LX-810 User Guide

Printing
Printed characters are not what you expected.
l The typestyle or characters that are set by your software
cannot be printed.
Check that the software is correctly installed for your
printer.
l The font setected by SelecType does not print.
Your software may be overriding your SelecType setting.
Check the printing style set in your software.
l The wrong characters are printed.
The wrong character table or the wrong international
character set may be selected. Check the DIP switch
settings. See the section on DIP switches in Chapter 3.
Also, you may be using the wrong cable or your cable may
not be properly connected.
The print position is not what you expected.
l Printing starts too high or too tow on the page.
Adjust the top margin set by your application software.
l All the text is printed on the same tine.
Set DIP switch 2-4 off.
l Page length does not match the length of the paper.
Change the page-length setting with DIP switches l-3 and
1-4. See the section on DIP switches in Chapter 3.
Check the page length set by your application software and
adjust it if necessary.
6-6 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)