Epson LX-810 User Guide

Operating the Control Panel
FORM FEED
When the printer is off line, press this button to eject a
single sheet of paper or to advance continuous paper to the
top of the next page.
LINE FEED
When the printer is off line and paper is loaded, press this
button to feed the paper one line, or hold it down to feed
paper continuously.
LOAD/EJECT
Use this button to feed the paper to the loading position or
to eject paper that is already loaded. The printer ejects
paper forward if the paper release lever is set to the single-
sheet position; it ejects paper backward (removes it from
the paper path) if the release lever is set to the continuous-
paper position.
SelecType
When the printer is on line, you use the FORM FEED, LINE FEED, and
LOAD/EJECT buttons to select the printer’s built-in character fonts.
NLQ
Press this button to select the NLQ Roman and NLQ Sans
Serif fonts. When you select Roman, the printer beeps
twice. When you select Sans Serif, the printer beeps three
times.
DRAFT
Press this button to select draft printing. When you select
draft printing, the printer beeps once.
Using the Printer
3-3

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)