Epson RC700 Series - Page 102

Functions 2. Part Names and Functions
84 RC700 Series Rev.3
2. Part Names and Functions
Control Unit
RC700
(2)
(3)
(1)
(Left side)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)(19)
(20)
(21)
(22)
(23)
RC700-A
(2)
(3)
(1)
(Left side)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)(19)
(20)
(21)
(22)
(23)
(1) Signature label (top panel)
The serial number of the Control Unit and other information are shown.
(2) LED
The LED indicates current operation mode.
(TEST, TEACH, AUTO, PROGRAM)
For details, refer to 2.1 LED & Seven Segment LED
(3) Seven-segment Display
Four-digit seven-segment LED displays the line number and the status of the
Controller (error number, warning number, status of Emergency Stop and Safety
Door).
For details, refer to 2.1 LED & Seven Segment LED
(4) M/C POWER connector
A connector for the Manipulator power source.
Connect the dedicated power cable attached to the Manipulator.
(5) Fan Filter
A protective filter is installed in front of the fan to filter out dust.
Check the condition of the filter regularly and clean it when necessary. A dirty filter
may result in malfunction of the robot system due to temperature rise of the Drive Unit.
For inspection, cleaning, and replacement, refer to the Maintenance 4.1 Fan Filter, 4.2
Fan.