Epson RC700 Series Original Instructions

Installation 4. First Step
RC700 Series Rev.3 67
(4) Turn ON the motors.
Check that the [Control Panel] tab is open. Click the <MOTOR ON> button.
(5) Move the Manipulator with Jog motion.
1. Select [Jog & Teach] tab.
2. Select “Joint” in [Jogging]-<Mode>.
3. Move the Manipulator by joint by clicking J1-J6 jog keys.
Manipulator can be moved by setting to other modes or setting the jog distance.

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4