Epson StylusPro 10000 - Page 110

EPSON Stylus Pro 10000/10000CF Revision B
Troubleshooting
S
ervice engineer require message
1
10
SERVICE REQ. 0003001B:GAP ADJUSTMENT RANGE ERROR
o
Problem
It is the adjustment value that is not able to adjust it to a hard target.
o Solution
n Gap (Bi-D, Uni-D) adjustment is done over again.
SERVICE REQ. 0003001C:TIME-OUT IN CASE OF NO PRINTFINISH
WITH ASIC
o
Problem
TBD
o Solution
TBD
SERVICE REQ. D0120013: MODULE COMMUNICATION ERROR
o
Problem
It causing from communication error between C362MAIN, C362DRV and HJFK
board).
o Solution
n Confirm the connection between the boards, especially HJFK board.
SERVICE REQ. D012001E: ENGINE SIDE ASIC COMMAND
TRANSMISSION OVER FLOW
SERVICE REQ. D012001F: ENGINE SIDE ASIC COMMAND
RECEIPT OVER FLOW
o
Problem
TBD
o Solution
TBD
SERVICE REQ. D0XXXXXX: THE PROGRAM ERROR
o
Problem
The error (the program error) that is not anticipating it
o Solution
n Program retouch
SERVICE REQ. 100000E0 : CPU ADDRESS ERROR
SERVICE REQ. 10000100 : CPU ADDRESS ERROR
SERVICE REQ. 10000180 : CPU RESERVATION INSTRUCTION
CODE EXCEPTION ERROR
SERVICE REQ. 100001A0 : CPU SLOT UNFAIR COMMAND
EXCEPTION ERROR
SERVICE REQ. 100005C0 : CPU DMA ADDRESS ERROR
SERVICE REQ. 10000XXX : CPU ERROR
o
Problem
Faulty of board defective or program
o Solution
n It confirms whether stand once again and raise the n power supply and reproduce.
In the case that it reproduces it is C362MAIN or C362DRV board exchange.