EasyManua.ls Logo

Epson StylusPro 10000 - Page 148

Epson StylusPro 10000
323 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
48
9. Remove twelve screws (M4x8) securing the Fan Duct
* Do not mind six screw of the upper sides are dropped inside the fan duct without
taking out.
Figure 4-74.
10. Open the fan duct as shown below.
Figure 4-75.
C H E C K
P O I N T
Screws are covered under sponge of fun duct.
C A U T I O N
Pay attention so as not to fail the sponge seal with the driver. (When it
fails the air leakage occurs and the adsorption power of the form
becomes low.) Remove the last screw while supporting with the hand,
because the fan duct falls when remove all the screw.
Do the cleaning, because dust etc. is adhering inside, when remove the
fan duct.
Screw
Screw
Fan Duct
Left
Right

Table of Contents

Related product manuals