55
12. Disconnect three connector cable, while push down the upper side of the head board.
Figure 4-93.
13. Remove the screw of the upper side while holding down the compression spring that is
attached to the screw of the lower part with the finger such that the spring of the hinge
does not miss and not jump out, then remove the hinge, compression spring and holder.
Also remove the hinge on the right side.
Figure 4-94.
Figure 4-95.
C A U T I O N
There is the danger that damages the substrate and also cause the
contact defectiveness of the FFC cable, if it does not draw out the
connector cable after the upper side of the head substrate is held
down.
C A U T I O N
Do not forget that the compression spring and spring holder (the black
plastics) are attached with the lower part screw.
Hinge L
Spring holder
Screw (lower side)
Hinge RCompression spring
To Next Page
Loading...
