Epson StylusPro 10000 - Page 90

EPSON Stylus Pro 10000/10000CF Revision B
Troubleshooting
T
roubleshooting Using the Messages 90
*1:The numbers of 4 columns that shows the kind of maintenance demand to,XXXX enter.
*2:Only when the panel display of the PG binding is PG setting = Large, the "h" is
displayed to the 20th columns of the liquid crystal devices.
*3:The processing progress status is displayed "%". (=100% the end)
*4:The display priority of case that the error occurred the plural is as it showed it in the
Table 3-2, “Printer Condition Display Priority,” on page 90.
NOZZLE CHECK
ERROR
Nozzle check error Error
Table 3-24,
“Nozzle check
error,” on
page 98
CLOSE INK
CART.COVER
Ink cover open
Error/
Warning
Table 3-25,
“Ink cover
open,” on
page 98 /
Table 3-6, “Ink
Cover Open,”
on page 93
WRONG CARTRIDGE
Wrong ink cartridge (Dye /
Pigment)
Error
Table 3-26,
“Wrong ink
cartridge,” on
page 98
INVALID CARTRIDGE Illegal ink cartridge Error
Table 3-27,
“Illegal ink
cartridge,” on
page 98
COMMAND ERROR Wrong printer driver Error
Table 3-28,
“Wrong IK
designation,”on
page 98
INK LOW Ink low Warning
Table 3-4, “Ink
Low,” on
page 93
READY Ready to print - -
NOT READY Not rady to print -
PRINTING Processing data - -
TURN PWR OFF AND ON Restarting requied - -
SERVICE.REQ.nn Fatal error Error
Table 3-29,
“Fatal Error,”
on page 99
Table 3-1. Panel display
LCD message Status Type Reference
WAIT In ink sequence - -
POWER OFF In power off sequence - -
PAUSE Pause - -
MAINTENANCE
REQ.nnnn
Maintenance call Warning
Maintenance
call, page 101
RESET Reset - -
Table 3-2. Printer Condition Display Priority
Prioyity Status
High Fatal errors / Restarting required
Paper jam
During power OFF sequence
Reset, timer IC reset/NVRAM clear
During power OFF sequence
During ink cartridge replacement
Cover open
Paper set lever is released during operation
Papersetleverisreleased
Table 3-1. Panel display
LCD message Status Type Reference