Epson TM-H6000 Service Manual

Rev. A Disassembly and Assembly 2-27
Confidential
TM-H6000/H6000P Service Manual
8. Fasten the frame plate to the right and the left frames using two screws. Sandwich the right
and left frames and tighten the screws.
9. Fix sensor circuit board A to the right frame with one screw.
10. Install the thermal print head assembly onto the main body.
Figure 2-23
11. Place in the head press springs into the press plate.
12. Install the press plate and the head press springs into the thermal print head assembly with
two screws.
13. Attach the intermediate circuit board to the right frame with one screw.
14. Insert the reduction gear into the reduction gear shaft. The larger diameter part should be
on the inner side.
15. Attach the receipt paper feed motor to the motor frame with two screws.
16. Attach the receipt paper feed motor to the left frame. Insert the reduction gear shaft into the
motor frame hole.
520 Relaxation plate
512
N.E. detector adjustment screw
502
screw(C.B.P-tite,3X8)
502
screw(C.B.P-tite,3X8)
526 Paper holder
547
Relaxation plate
fixing plate
540
screw(C.B.S-tite F,3X6)
514
Right frame
543
Cover open detector
lead wire
541
Sensor
circuit board
assembly
502
screw(C.B.P-tite,3X8)
515
Left frame
513 Head caution seal
510
Paper detector
assembly
546
Paper cutter cover
assembly
538 E-ring(1.5)
537 Hexagon nut
517
Frame plate
540
screw(C.B.S-tite F,3X6)

Epson TM-H6000 Specifications

General

Brand	Epson
Model	TM-H6000
Category	Printer
Language	English