Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
120 119
TM-T88III series
Specification
(STANDARD)
B
GS ( A pL pH n m
[Name] Execute test print
[Format] ASCII GS ( A
pL pH n m
Hex 1D 28 41
pL pH n m
Decimal 29 40 65 pL pH n m
[Range] (
pL+(pH×256))=2 (pL=2, pH=0)
0
≤ n ≤ 2, 48 ≤ n ≤ 50
1
≤ m ≤ 3, 49 ≤ m ≤ 51
[Description]
• Executes a test print with a specified test pattern on a specified paper.
• pL and pH specifies the number of the parameter such as n, m to (pL + (pH × 256)) bytes.
n specifies the paper to be tested.
n Paper
0, 48 Basic sheet (paper roll)
1, 49
2, 50
Paper roll
m specifies a test pattern.
m Test pattern
1, 49 Hexadecimal dump
2, 50 Printer status print
3, 51 Rolling pattern print
[Details] • This command is enabled only when processed at the beginning of a line in standard mode.
• This command is no effect in page mode.
• When this command is received during macro definition, the printer ends macro definition and
begins performing this command.
• After the test print is finished, the printer resets itself automatically. Therefore, the
already-defined data before this command is executed, such as an user-defined characters,
downloaded bit image, and macro, becomes undefined, and the receive buffer and print
buffer are cleared, and each setting returns to the default value. The printer also re-reads
the DIP switch settings .
• The printer cuts the paper at the end of the test print.
• The printer goes BUSY while this command is executed.
To Next Page
Loading...
Need help?
General
