Epson TM-T88III series - Installation

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
10 9
TM-T88III series
Specification
(STANDARD)
B
3) Vibration resistance: When Packed: Frequency: 5 to 55 Hz
Acceleration: Approximately 19.6 m/s
2
{2 G}
Sweep: 10 minutes (half cycle)
Duration: 1 hour
Directions: x, y, and z
No external or internal damage should be found after the vibration test,
and the unit should operate normally.
4) Impact resistance: When Packed: Package: EPSON standard package
Height: 60 cm {23.6"}
Directions: 1 corner, 3 edges, and 6 surfaces
No external or internal damage should be found after the
drop test, and the unit should operate normally.
When unpacked: Height: 5 cm {1.97"}
Directions: Lift one edge and release it
(for all 4 edges).
When the printer is not printing, no external or internal damage should
be found after the drop test.
5) Acoustic noise(Operating): When using autocutter:
Approximately 55 dB (Bystander position)
When not using autocutter:
Approximately 45 dB (Bystander position)
1.13 Installation
The TM-T88III series printer must be installed horizontally.
(Vibration during paper cutting and using a drawer should be considered. Take measures to prevent
the printer from moving. Affixing tapes are provided as an option.)
An optional hanging bracket can attach the printer to a wall. (Following the procedures describes in
the installation manual, install the wall mount and change the location of the paper roll near-end sensor,
then install the paper roll stopper and other parts.)