Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
5 4
TM-T88III series
Specification
(STANDARD)
B
1.3 Autocutter
Partial cut: Cutting with one point left uncut
NOTE: To prevent dot displacement, after cutting, paper must be fed approximately 1 mm {14/360"}
or more before printing.
1.4 Paper Roll Supply Device
1) Supply method: Drop-in paper roll
2) Near-end sensor:
a) Detection method: Microswitch
b) Paper roll spool diameter: Inside: 12 mm {0.47"}
Outside: 18 mm {0.71"}
c) Near-end adjustment: Can be adjusted by changing the position of the adjusting screw.
Fixed position #1 (approximately 23 mm {0.9"})
#2 (approximately 27 mm {1.06"})
NOTE: You can use a command to stop printing upon detection of a paper near-end.
1.5 Paper Specification
1) Paper type: Specified thermal paper
2) Form: Paper roll
3) Paper width: 79.5 ± 0.5 mm {3.13 ± 0.02"}
4) Paper roll size: Roll diameter: Maximum 83 mm {3.26"}
Take-up paper roll width: 80 +0.5/–1.0 mm {3.15+0.02/–0.04"}
5) Specified paper: Specified thermal roll paper:
NTP080-80
[Original paper: TF50KS-E Nippon Paper Industries Co., Ltd.]
Packaged roll paper:
[Original paper: PD160R (Oji Paper Mfg. Co., Ltd.)]
In Japan: Nakagawa Manufacturing Co., Ltd.
In U.S.A.: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
The following paper can be used instead of the specified paper above:
Original paper: PD190R (Oji Paper Mfg. Co., Ltd.)
P350(F380), P310, P300
(Kanzaki Specialty Papers, Inc. (U.S.A.))
AF50KS-E (Jujo Thermal Oy (Finland))
6) Paper roll spool diameter: Inside: 12 mm {0.47"}
Outside: 18 mm {0.71"}
NOTE: Paper must not be pasted to the paper roll spool.
To Next Page
Loading...
