Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
88 87
TM-T88III series
Specification
(STANDARD)
B
ESC 3 n
[Name] Set line spacing
[Format] ASCII ESC 3
n
Hex 1B 33 n
Decimal 27 51 n
[Range] 0 ≤ n ≤ 255
[Description] Sets the line spacing to [
n × vertical or horizontal motion unit].
[Details]
• The line spacing can be set independently in standard mode and in page mode.
• The horizontal and vertical motion unit are specified by GS P. Changing the horizontal or
vertical motion unit does not affect the current line spacing.
• The GS P command can change the horizontal (and vertical) motion unit. However, the value
cannot be less than the minimum vertical movement amount, and it must be in even units of
the minimum vertical movement amount.
• In standard mode, the vertical motion unit (y) is used.
• In page mode, this command functions as follows, depending on the starting position of the
printable area:
① When the starting position is set to the upper left or lower right of the printable area using
ESC T, the vertical motion unit (y) is used.
② When the starting position is set to the upper right or lower left of the print able area
using
ESC T, the horizontal motion unit (x) is used.
• The maximum paper feed amount is 1016 mm {40"}. Even if a paper feed amount of more
than 1016 mm {40"} is set, the printer feeds the paper only 1016 mm {40"}.
[Default] Line spacing equivalent to approximately 4.23mm {1/6"}.
[Reference]
ESC 2, GS P
To Next Page
Loading...
Need help?
General
