Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
152 151
TM-T88III series
Specification
(STANDARD)
B
FS S n1 n2
[Name] Set left- and right-side Kanji character spacing
[Format] ASCII FS S
n1 n2
Hex 1C 53
n1 n2
Decimal 28 83
n1 n2
[Range] 0
≤ n1 ≤ 255
0
≤ n2 ≤ 255
[Description] Sets left- and right-side Kanji character spacing
n1 and n2, respectively.
• When the printer model used supports GS P, the left-side character spacing is [n1 ×
horizontal or vertical motion units], and the right-side character spacing is [
n2 × horizontal or
vertical motion units].
[Notes]
• When double-width mode is set, the left- and right-side character spacing is twice the normal
value.
• The horizontal and vertical motion units are set by GS P. The previously specified character
spacing does not change, even if the horizontal or vertical motion unit is changed using
GS P.
• The value cannot be less than the minimum horizontal movement amount, and must be in
even units of the minimum horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode, depending on
starting position of the printable area as follows:
① When the starting position is set to the upper left or lower right of the printable
area using
ESC T, the horizontal motion unit (x) is used.
② When the starting position is set to the upper right or lower left of the printable
area using
ESC T, the vertical motion unit (y) is used.
③ The maximum right-side spacing is 255/180 inches for the paper roll and is
approximately 35.983 mm {255/150 inches}. Any setting exceeding the maximum
is converted to the maximum automatically.
[Default]
n1 = 0, n2 = 0
[Reference]
GS P
To Next Page
Loading...
Need help?
General
