Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
133 132
TM-T88III series
Specification
(STANDARD)
B
GS a n
[Name] Enable/Disable Automatic Status Back (ASB)
[Format] ASCII GS a
n
Hex 1D 61
n
Decimal 29 97
n
[Range] 0
≤ n ≤ 255
[Description] Enables or disables ASB and specifies the status items to include, using
n as follows:
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Drawer kick-out connector pin 3 status disabled.
On 01 1 Drawer kick-out connector pin 3 status enabled.
1 Off 00 0 Online/offline status disabled.
On 02 2 Online/offline status enabled.
2 Off 00 0 Error status disabled.
On 04 4 Error status enabled.
3 Off 00 0 Paper roll sensor status disabled.
On 08 8 Paper roll sensor status enabled.
4-7 - - - Undefined.
[Details] • If any of the status items in the table above are enabled, the printer transmits the status when
this command is executed. The printer automatically transmits the status whenever the
enabled status item changes. The disabled status items may change, in this case, because
each status transmission represents the current status.
• If all status items are disabled, the ASB function is also disabled.
• If the ASB is enabled as a default, the printer transmits the status when the printer data
reception and transmission is possible at the first time from when the printer is turned on.
• The following four status bytes are transmitted without confirming whether the host is ready to
receive data. The four status bytes must be consecutive, except for the XOFF code.
• Since this command is executed after the data is processed in the receive buffer, there may
be a time lag between data reception and status transmission.
To Next Page
Loading...
Need help?
General
