EasyManuals Logo

Epson TM-T88III series User Manual

Epson TM-T88III series
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
121 120
TM-T88III series
Specification
(STANDARD)
B
GS / m
[Name] Print downloaded bit image
[Format] ASCII GS /
m
Hex 1D 2F
m
Decimal 29 47
m
[Range] 0
m 3, 48 m 51
[Description] Prints a downloaded bit image using the mode specified by
m.
m selects a mode from the table below:
m Mode Vertical Dot Density Horizontal Dot Density
0, 48 Normal 180 dpi 180 dpi
1, 49 Double-width 180 dpi 90 dpi
2, 50 Double-height 90 dpi 180 dpi
3, 51 Quadruple 90 dpi 90 dpi
[dpi: dots per 25.4 mm {1"}]
[Details]
This command is ignored if a downloaded bit image has not been defined.
In standard mode, this command is effective only when there is no data in the print buffer.
This command has no effect in the print modes (emphasized, double-strike, underline,
character size, or white/black reverse printing), except for upside-down printing mode.
If the downloaded bit-image to be printed exceeds the printable area, the excess data is not
printed.
Refer to Figure 3.12.3 for the downloaded bit image development position in page mode.
If the printing area width set by GS L and GS W is less than one line in vertical, the following
processing is performed only on the line in question:
The printing area width is extended to the right up to one line in vertical. In this case,
printing does not exceed the printable area.
If the printing area width cannot be extended by one line in vertical, the left margin is
reduced to accommodate one line in vertical.
[Reference]
GS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson TM-T88III series and is the answer not in the manual?

Epson TM-T88III series Specifications

General IconGeneral
Print MethodThermal line printing
Resolution180 dpi
Paper Width79.5 ± 0.5 mm
Print Speed150 mm/sec
InterfaceUSB, Serial, Parallel, Ethernet
AutocutterPartial cut
Dimensions145 x 195 x 148 mm (W x D x H)
Power24 V DC ±10%
Power SupplyExternal power supply (depending on model)
Paper Thickness0.06 to 0.085 mm

Related product manuals