2. Enter the printer's IP address into a browser to run Web Cong.
3. Select the Network tab > Wi - Fi Di r e c t .
4. Select Disable for Wi - Fi D i r e c t .
5. Click Next
6. Check the message, and then select OK.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Select Settings on the home screen.
2. Select System Administration > Network Settings > Wi - Fi S e tu p .
3. Select Disable Wi-Fi.
4. Check the message, and then press the
u
button.
5. Press the OK button.
e screen automatically closes aer a specic length of time if you do not press the OK button.
Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control
Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specic device, disconnect from the device
instead of the printer.
1. Select Settings on the home screen.
2. Select System Administration > Network Settings > Wi - Fi S e tu p > Wi - Fi D i r e c t S e t u p .
3. Select Disable Wi-Fi Direct.
4. Check the message, and then press the
u
button.
5. Press the OK button.
e screen automatically closes aer a specic length of time if you do not press the OK button.
Administrator's Guide
Solving Problems
57