EasyManua.ls Logo

Epson WF-7210 series - E-12

Epson WF-7210 series
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Solutions:
Check the following.
e default gateway address is correct if you set the printer's TCP/IP Setup setting to Manual.
e device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the Network Status part
on the network connection report.
E-12
Message:
Conrm the following -Entered security key/password is correct -Index of the security key/password is set to the
rst number -IP address, subnet mask, or default gateway setup is correct Contact your network administrator for
assistance.
Solutions:
Check the following.
Other devices on the network are turned on.
e
network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them
manually.
e network addresses for other devices (subnet mask and default gateway) are the same.
e IP address does not conict with other devices.
If still does not connect your printer and network devices
aer
conrming
the above, try the following.
Turn o the access point. Wait for about 10 seconds, and then turn it on.
Make network settings again using the installer. You can run it from the following website.
http://epson.sn > Setup
You can register several passwords on an access point that uses WEP security type. If several passwords are
registered, check if the rst registered password is set on the printer.
E-13
Message:
Conrm the following -Entered security key/password is correct -Index of the security key/password is set to the
rst number -Connection and network setup of the PC or other device is correct Contact your network
administrator for assistance.
Solutions:
Check the following.
Network devices such as an access point, hub, and router are turned on.
e TCP/IP Setup for network devices has not been set up manually. (If the printer's TCP/IP Setup is set
automatically while the TCP/IP Setup for other network devices is performed manually, the printer's network
may
dier
from the network for other devices.)
Administrator's Guide
Solving Problems
65

Table of Contents

Other manuals for Epson WF-7210 series

Related product manuals