Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
113
11.6.3.5.6 priority
Use this command to configure the spanning tree priority globally for the
ECN.
Command level: ecn330(config)#.
Syntax
ecn spanning-tree priority <priority>
Arguments:
• priority <priority> - Priority of the bridge. (Range: 0 - 65535).
(Range: 0-61440, in steps of 4096; Options: 0, 4096, 8192, 12288,
16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056, 49152,
53248, 57344, 61440).
Default Settings
32.768
Command Usage
Bridge priority is used in selecting the root device, root port, and designated
port. The device with the highest priority becomes the STA root device.
However, if all devices have the same priority, the device with the lowest
MAC address will then become the root device.
Example
ecn330(config)# ecn spanning-tree priority 16384
11.6.3.5.7 status
Use this command to enable or disable the spanning tree.
Command level: ecn330(config)#.
Syntax
ecn spanning-tree status {enable|disable}
Arguments:
To Next Page
Loading...
