Command Line Interface
114 1553-CNH 160 0787 Uen PA2 2005-09-23
• status enable/disable – Enable or disable spanning tree.
Note: Telnet connection will be lost.
Default Settings
Disabled.
Command Usage
The Spanning Tree Algorithm (STA) can be used to detect and disable
network loops, and to provide backup links between switches, bridges or
routers.
Example
ecn330(config)# ecn spanning-tree status disable
11.6.3.5.8 transmission-limit
Use this command to configure the minimum interval between the trans-
missions of consecutive RSTP BPDUs (Bridge Protocol Data Units).
Command level: ecn330(config)#.
Syntax
ecn spanning-tree transmission-limit <seconds>
Arguments:
• transmission-limit <seconds> - The transmission limit in
seconds. Range 1-10 seconds.
Default Settings
3
Command Usage
This command limits the maximum transmission rate for BPDUs.
To Next Page
Loading...
