Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
153
Command level: ecn330#.
Syntax
show exn <node> {general|line}
Arguments:
• exn <node> - Insert the node no. in the format a.b.
• general - Show the general settings, that is information about
site, packet distribution, load distribution and link mode.
• line - Show the configuration of the E1 lines, that is information
about operational state, line type, coding, alarm, synchronization
mode and test mode settings.
Default Setting
None.
Command Usage
This command is used to display information about the EXN104 settings in-
cluding the line settings of the E1 lines. The state of each of the 4 E1 lines
can be shown, which is: disabled, in operation, testing or unknown. The
type and the coding of the line are shown. The alarm and synchronization
mode (master or slave) are also shown as well as the state of loop test.
Example
ecn330# show exn 3.100 general
ecn330# show exn 3.100 line
11.8.5 esn
Use this command to display settings of the ESN108 switch, the ESN310
switch and the ECN switch. For the ESN108 the command is used for
showing the spanning-tree parameters, to show if there is power on the up-
link port, and to show the physical mode of a port, that is the duplex mode
and interface speed.
Regarding the ESN310 switch and the ECN switch, the command can be
used to show the spanning tree parameters and to show the link aggrega-
tion trunks for the switch.
To Next Page
Loading...
