Command Line Interface
154 1553-CNH 160 0787 Uen PA2 2005-09-23
Note: Link aggregation trunks can only be set for the ESN310 switch, the
ESN310 switch, the ECN switch and not for the ESN108 switch.
Command level: ecn330#.
Syntax
show esn <esn108node> {power-on-uplink|port
<port>
|spanning-tree|port <port>
phymode} show esn <esn310node> {spanning-tree|link-
aggregation|port <port> spanning-tree}
Arguments:
• esn <esn108node> - Insert the node no. of the ESN108 in the
format a.b in the range 1.0 to 24.0, and 101.0 to 124.0, and 201.0
to 224.0 and so on up to 701.0 to 724.0
• esn <esn310node> - Insert the node number of the ESN310
switch or the ECN switch in the format a.b in the range 0.1 to 0.7
• port <port> phy-mode – Insert the port number. For ESN108
the range is 1 to 9. For the ESN310 switch and the ECN switch the
range is 1 to 24.
• power-on-uplink – Shows the PoE status of the uplink ESN108
port, that is if the uplink port has been set to enable PoE, disable
PoE
Note: The optical port 9 can only be read not set. None or 2 different in-
terfaces can be installed on port 9. “- -“ will be displayed by the
show esn 3.0 port 9 phymode command when no interface
is installed on port 9.
Default Setting
None.
Command Usage
This command is used to display information about power on the uplink port
on the ESN108, information of link aggregation and spanning tree parame-
ters for both the ESN108, the ESN310 switch and the ECN switch. Span-
ning tree parameters can be displayed for each port.
To Next Page
Loading...
