Ericsson T39 - Page 188

AT Commands Modem Terminated 186
+FDCS FDCS Indication
5.6.3 Use scenarios
FDT Handling
This scenario will demonstrate a transmission with the following steps:
• Enable fax data transmission.
• Send two pages, 1-D data, no errors.
Description: Reports DID/DCS/DTC frame. This message may be generated in execution of
AT+FDT or AT+FDR, before the CONNECT result code, if new DCS frames are
generated or received.
Unsolicited result code:+FDCS: <vr>,<br>,<wd>,<ln>,<df>,<ec>,<bf>,<st>
Parameters: See AT+FDCC.
TE command TAE response
AT+FCLASS=2 OK
AT+FLID=”local_ID” OK
ATD<dial_string>
+FCON
[+FCSI: ”<csi>”]
+FDIS: <dis_codes>
OK
AT+FDT
+FDCS: <dcs codes>
CONNECT
<XON>
OK
<First page data>
<DLE><ETX>
AT+FET=0
+FPTS: 1
OK
CONNECT
<XON>
AT+FDT
OK
<Second page data>
<DLE><ETX>
AT+FET=2
+FPTS: 1
+FHNG: 0
OK