-- 4 --
TOCe
Rights reserved to alter specifications without notice.
11 WELD DATA SETS 41.................................................
11.1 Example: Saving welding data on a memory card 41..............................
11.2 Recalling welding data from a memory card 42...................................
11.3 Deleting welding data from a memory card 42....................................
12 CONFIGURATION MENU 42...........................................
12.1 Code lock 42................................................................
12.1.1 Lock code mode 43......................................................
12.1.2 Set / change lock code 44................................................
12.2 Remote control configuration 44................................................
12.2.2 Configuring a digital remote control 45......................................
12.2.3 Configuring an analogue remote control 45..................................
12.3 MIG/MAG defaults 46.........................................................
12.3.1 Gun trigger mode (2--stroke / 4--stroke) 46..................................
12.3.2 Soft keys setup 47.......................................................
12.3.3 Voltage measurement for dip 49...........................................
12.3.4 4--stroke configuration 49.................................................
12.4 MMA defaults 50.............................................................
12.4.1 Hot start amplitude 50....................................................
12.4.2 Hot start duration 50.....................................................
12.4.3 Droplet welding 50.......................................................
12.5 General defaults 51...........................................................
12.5.1 Fast mode soft keys 51...................................................
12.5.2 Double start sources 51..................................................
12.5.3 Panel remote enable 51..................................................
12.5.4 Auto save mode 52......................................................
12.5.5 T rigger weld data switch 52...............................................
12.5.6 Quality data logging 53...................................................
12.6 Multiple wire feeders 54.......................................................
12.6.1 Weld data 55............................................................
12.7 Unit of length 55.............................................................
13 QUALITY FUNCTIONS 55..............................................
13.1 Saving quality data on a compact flash card 56...................................
14 PRODUCTION STATISTICS 57.........................................
15 ERROR L OG 58.......................................................
15.1 Deleting error messages 58....................................................
15.2 Reviewing error summary 58...................................................
15.3 Error code list 59.............................................................
15.4 Error code descriptions 60.....................................................
16 USER--DEFINED SYNERGIC DATA 63...................................
16.1 Specify voltage/wire co--ordinates 63............................................
16.1.1 Dip/spray 63............................................................
16.1.2 Pulsing 64..............................................................
16.2 Specifying the valid wire/gas combination 64.....................................
16.3 Creating user--defined wire/gas options 65.......................................
16.4 Deleting a user--defined synergic line 66.........................................
17 L IMIT EDITOR 66.....................................................
18 OTHER INFORMATION 67.............................................
18.1 ESAB Logic Pump (Water lock) 67..............................................
WIRE AND GAS COMBINATIONS 68......................................
To Next Page
Loading...
